Daikin Altherma 4 H Guide: R290 Heat Pump

The Altherma 4 H is Daikin’s newest heat pump, using natural refrigerant R290 (propane). It brings a new touchscreen, built-in Wi-Fi and some important safety features.

Models

  • EPSK06–14A: launched April 2025.
  • EPSKS04/06/07A: compact single-phase models announced January 2026, with 70°C flow at −15°C, operation down to −28°C, factory-fitted anti-freeze valves, a gas sensor with automatic fan, WLAN as standard and remote software updates.
  • Indoor: EPSX(B) ECH2O (P30/P50 = 300/500 litres), EPVX floor with tank (“F”) or EPBX wall (“W”).

R290 safety

R290 is flammable, so Altherma 4 has gas sensors indoors and outdoors.

  • A0-02: indoor gas sensor detected a leak. A0-26: outdoor gas sensor detected a leak. The unit stops and needs a manual reset.
  • If you see either: ventilate, keep ignition sources away, don’t reset or open the unit, and call your installer urgently. For a gas smell from a gas appliance, call 0800 111 999.
  • Sensor faults: C0-14/19 (manual), C0-15/20 (automatic) indoor; H0-02/04 (manual), H0-06/07 (automatic) outdoor.

Engineers need R290 competence.

The touchscreen menus

Different from Altherma 3: [1] Main zone, [2] Additional zone, [3] Space heating/cooling, [4] Domestic hot water, [5] Settings, [6] Information, [7] Maintenance mode, [8] Connectivity, [9] Energy, [10] Configuration wizard, [11] Malfunctioning. Users switch on Advanced settings at [5.13]; installer level is separate. Field codes are three digits.

Key settings

  • Weather curve [1.8] (2-point), shift [1.27], increase around 0°C [1.26].
  • Hot water: [4.1] single heat-up, [4.3] manual setpoint, [4.4] Powerful setpoint.
  • Quiet mode [5.2.1]/[5.2.2]; water pipe freeze prevention [5.36].

Minimum flow

Required 20/22/24 l/min (EPSX07/10/14) for start-up, defrost, cooling and backup heater.

Software v4

Version 4 (2026) added per-zone minimum flow, defrost energy compensation [5.33], hot water priority options, and changed manual overrides to end at the next schedule block. New codes include E3-26/27 (low differential pressure in defrost).

Error reset types

Every code shows whether it resets automatically, needs a manual interface reset (installer) or a power cycle.

FAQ

Does Onecta work?

Yes, Wi-Fi is built in (menu [8.3]).

Is 8H-09 a fault?

No, it’s a normal backup heater relay check at start-up.

Does it need glycol?

The EPSKS has factory anti-freeze valves; your installer designs frost protection.

Related guides

Safety first

Owners can safely check pressure, valves, the controller and the outdoor unit from outside. Anything involving refrigerant, electrics, opening the unit or resetting internal cut-outs is a job for a qualified engineer (F-gas certified for refrigerant work, and R290-competent for Altherma 4).

Still stuck?

Ask the Heat Pump Assistant with your model code and what your screen shows, and you’ll get an answer tailored to your system. If it’s time for a check-up or a fault needs hands-on attention, Book a Service. You can also browse all our Help Guides.