Vaillant sensoCOMFORT VRC 720 Owner’s Guide

The sensoCOMFORT VRC 720 is the system control covered by Vaillant’s VRC 720/3 operating and installation instructions — the usual controller with the aroTHERM plus /6.

Getting around

  • Press the home/back button once for the basic display, twice for the menu.
  • The main menu has three parts: MENU | CONTROL, MENU | INFORMATION and MENU | SETTINGS.
  • The basic display shows symbols for noise reduction, Green iQ and the spanner for faults or maintenance.

Heating modes

In MENU | CONTROL | Zone | Heating | Mode:

  • Manual: holds the desired temperature all the time.
  • Time-contr.: a weekly planner with up to 12 time periods a day. Outside them it uses the set-back temperature, or switches off, depending on how your installer set it up.
  • Off: heating off with frost protection on. Hot water still works.

Hot water

  • DHW presetting Comfort or Eco (factory Comfort). Eco reheats to the Reduced DHW temperature after a big draw-off. The Reduced DHW temperature factory setting is 49 °C.
  • Mode Manual, Time-contr. (up to 3 periods a day) or Off, plus the DHW temperature.
  • Hot water boost heats the cylinder once, now.

Absence and temporary changes

  • Absence: set from and to dates. Heating drops to the set-back temperature (factory 15 °C), hot water is off and the anti-legionella cycle is skipped.
  • There’s no quick override key. Switch Mode to Manual for a while and back to Time-contr. later, or use the timed override in the myVAILLANT app.
  • Time programme assistant sets Monday to Friday and the weekend in one go (it overwrites your weekly planners).

Useful information screens

MENU | INFORMATION shows current room and cylinder temperatures, water pressure, energy data (estimates only), your installer’s contact details and the serial number.

Settings to leave alone

  • Installer level is code-protected. We can’t provide installer codes.
  • Never use Factory settings. It wipes your installer’s set-up.
  • Language rescue: press home twice, choose the last item (SETTINGS), then the second item, then your language.

Common fixes

  • Display dark or frozen: hold the top-right button for over 5 seconds to restart it. If it’s still stuck, switch the heat pump off at its isolator for about a minute and back on.
  • Button lock: press the top-right button for about 1 second.
  • “Mode: Back-up heater if fault occurs”: the heat pump has failed and limp-home is active. You can choose Off, Heating, DHW or both for the back-up until the engineer comes, but running on the back-up is expensive.

FAQ

Can I change the heat curve on the sensoCOMFORT?

The heat curve is an installer-level setting on the controller. Ask your installer to set it.

What does Green iQ mean?

It’s the most energy-efficient mode, where your system supports it.

Related guides

Safety first

Owners can safely check pressure, valves, the controller and the outdoor unit from outside. Anything involving refrigerant, electrics, opening the unit or resetting internal cut-outs is a job for a qualified engineer. aroTHERM plus and aroTHERM pro units use R290, so refrigerant work needs an engineer competent with flammable refrigerants.

Still stuck?

Ask the Heat Pump Assistant with your model, controller and what your screen shows, and you’ll get an answer tailored to your system. If it’s time for a check-up or a fault needs hands-on attention, Book a Service. You can also browse all our Help Guides.

Independent guide, not affiliated with or endorsed by Vaillant.