Cosy Octopus Schedule for a Vaillant Heat Pump

A heat pump tariff can cut running costs a lot, but only if your controller is set to use the cheap windows. Tariff terms change, so check your supplier’s current times.

Match your supplier’s cheap windows

Tariff times are set by your energy supplier, not by Vaillant, and they change. Check your current tariff before you programme the controller. The sensoCOMFORT can follow the windows you enter.

Setting it on sensoCOMFORT

  1. Set heating to Time-contr. You can have up to 12 periods a day.
  2. Ask your installer to use Set-back mode Normal, so the heating holds the lower temperature rather than switching off.
  3. Ask your installer to programme periods that match your cheap windows, and to keep temperature swings modest (about 1 to 2 °C) so the heat pump is not asked to jump between very different flow temperatures.
  4. Hot water on Time-contr. (up to 3 periods a day), inside cheap windows where you can.
  5. Ask your installer to put the anti-legionella day and time inside a cheap window, ideally the afternoon.

The myVAILLANT app’s weekly planner can do the same remotely.

Other tariffs

  • Agile Octopus: prices change every half hour. Vaillant controls can’t read prices, so owners use fixed schedules around typical cheap times, or third-party optimisers. These aren’t Vaillant-supported.
  • Intelligent Octopus Go and similar overnight tariffs: use your supplier’s current cheap window for overnight hot water and some pre-heating.
  • Economy 7 / radio teleswitch: the RTS signal is being phased out. If your heat pump’s lock-out relied on it, ask your supplier and installer what replaces it.

FAQ

Should I turn the heating off at peak time?

No. Drop the desired temperature a little rather than switching heating off. Don’t switch it off when popping out either.

What does the Tariffs menu on sensoCOMFORT do?

It mainly matters for hybrid systems, where it helps choose between heat pump and boiler.

Related guides

Safety first

Owners can safely check pressure, valves, the controller and the outdoor unit from outside. Anything involving refrigerant, electrics, opening the unit or resetting internal cut-outs is a job for a qualified engineer. aroTHERM plus and aroTHERM pro units use R290, so refrigerant work needs an engineer competent with flammable refrigerants.

Still stuck?

Ask the Heat Pump Assistant with your model, controller and what your screen shows, and you’ll get an answer tailored to your system. If it’s time for a check-up or a fault needs hands-on attention, Book a Service. You can also browse all our Help Guides.

Independent guide, not affiliated with or endorsed by Vaillant.